Crossbow Authority
Peep Sight: What It Is on a Bow and Why Crossbows Skip It
Updated

Peep Sight: What It Is on a Bow and Why Crossbows Skip It

What a peep sight is on a compound bow, how it lines up with sight pins, and why crossbow shooters get the same rear-sight job from the scope and a consistent stock position.

What a peep sight is in plain terms

What a peep sight is meaning: A peep sight is a small ring tied into a bowstring that acts as a rear sight at full draw; crossbows use a scope and a stock instead.

Also called: rear peep, string peep, bow peep, peep sights

A peep sight is a small ring or aperture tied into a bowstring. Bowhunter-education courses describe it as attaching to the bowstring and acting as a rear sight at full draw to improve accuracy. The archer looks through the peep and holds the sight pin in the centre of the target and in the centre of the peep, the way a rifle shooter lines up a rear and front sight.

A crossbow does not use a string peep. The string sits in the latch, away from your eye, and aiming is done through a scope or red dot mounted on the rail. The job a peep does, fixing where your eye sits, falls to the stock: a steady cheek position and the scope's eye relief put your eye in the same place each shot.

Bow shooters who switch notice the difference in maintenance too. A peep can rotate as a new string settles and has to be re-aligned, which is one less job on a crossbow. Our crossbow vs compound bow guide compares the two aiming systems.

Why it matters

It explains one reason crossbows reach basic accuracy sooner: there is no peep to align at full draw, because the string is held mechanically and the scope does the aiming.

For former archers, it is a reminder that eye position still matters. The stock fit and cheek position take over the job the peep used to do.

How to read it on a spec sheet

  • Treat "peep" in crossbow listings as unusual; crossbow sighting is listed as a scope, red dot or open sights.
  • On a bow package, check whether a peep is included and pre-installed in the string.
  • For a crossbow, read the scope's eye relief and the stock's adjustability instead.
  • If a listing compares a crossbow and a bow, a peep line usually applies only to the bow.

Common mistakes

  • Expecting to fit a string peep to a crossbow; it would sit nowhere near your eye.
  • Assuming a crossbow needs no attention to eye position because it has no peep.
  • Forgetting that a bow peep may rotate after a string change.
  • Mixing up a peep sight with a red dot or reflex sight.

Frequently Asked Questions

  1. What is a peep sight?

    It is a small ring tied into a bowstring that works as a rear sight at full draw. You look through it and centre the sight pin on the target and in the peep for a consistent aim.

  2. Do crossbows use peep sights?

    Not on the string. A crossbow string is held in the latch away from your face, so a string peep would be useless. Crossbows aim through a scope or red dot, and the stock sets your eye position.

  3. What replaces the peep on a crossbow?

    A consistent cheek position on the stock, plus the scope's eye relief. Together they put your eye in the same place each shot, which is what the peep does for an archer.

  4. Why does a peep sight rotate?

    A bowstring twists and settles as it stretches, which can turn the peep away from the archer's eye. Archers re-align it, often after a new string, which is a job crossbow shooters do not have.

Related guides

Guides where peep sight shapes a real choice.

Definitions are general information. Manufacturer figures vary, so follow your crossbow's manual and verify local laws with the relevant authority.